Cambridge Audio 540D V2 DVD Player User Manual


 
540D V2azur
13
Audio setup menus
With the Audio setup menu selected, use the and arrows to move
to the desired sub-menu. Use the Navigation arrows () to
adjust the settings and press the Enter button to confirm your selection.
See below for the Audio Setup menu structure:
Speaker setup
Downmix
Stereo
-
When in Stereo mode any DD 5.1 or PLII 5.1 content will be
downmixed to Stereo and output from the Front Left and Right sockets
of the 5.1 output only.
Off -
When Off, full 5.1 output will be available (depending on disc).
Note:
The 540D V2 also features a separate set of permanent Stereo
Outputs that will always output true Stereo (for Stereo material) or
downmixed Stereo from 5.1 regardless of the above setting.
If
Downmix
is
‘On’,
only
the
Front
Speaker
size
and
Sub On/Off
ca
n
be
selected.
In the next series of menus for each speaker type, select from ‘Large’
and ‘Small’ for each speaker (‘Large’ and ‘Small’ are used to describe
each speaker in terms of bass response and do not necessarily reflect
the actual physical size of the speaker).
Large
=
Speakers with an extended low frequency response of
approximately 20-40Hz to 16-20kHz (floorstanders or high quality larger
stand-mounted speakers).
Small
=
Speakers with a less extended low frequency response of
approximately 80-100Hz to 16-20kHz (small stand-mounted, bookshelf
or satellite speakers).
Setting each speaker allows the 540D V2 to perform what is called Bass
Management and to direct low frequency bass from music and the Low
Frequency Effects channel of surround sound material away from
speakers not able to reproduce it and to the subwoofer channel instead.
Front, Centre and Rear Speakers
These settings allow selection of ‘Large’ or ‘Small’ speaker ‘size’ as
described above.
Note:
Only the three configurations All speakers Large, Large Fronts /
Centre with Small Rears and All speakers Small are supported by the
540D V2.
Test Tone
With the unit in Stop mode, the disc drawer open and Downmix set to
‘Off’, select ‘On’ to carry out a test tone procedure. The 540D V2 will
then play ‘white-noise’ sound from each of the 5.1 outputs in turn. They
can be used to adjust the levels of your external amplifier/receiver or
speaker system so that each channel is at approximately the same level
for best surround-sound performance. Listen to each channel in turn as
the 540D V2 cycles through them and adjust the level on your
amplifier/receiver or speaker system so that each channel sounds the
same in terms of loudness (bear in mind smaller speakers and
subwoofers etc will sound different in terms of the tone of the sound but
the overall level sound be matched).
SPDIF (and TOSlink Optical) Output
Three
options
are
available:
Off,
Raw
Bitstream
and
PCM
Stereo.
If PCM Stereo is selected the digital output will always be Digital PCM
Stereo (LPCM) for use with a DAC, recording to a MD or CD-R machine
etc.
If Raw bitstream is selected the output will either be PCM Stereo for
Stereo disc/soundtracks or a surround-sound bitstream from surround-
sound soundtracks for decoding by an external AV Receiver, see below:
* 48kHz or 96kHz depending on soundtrack bit depth and LPCM limit
set as below.
LPCM Out
Selects whether the SPDIF LPCM output from DVDs can be at 96kHz
maximum sample rate (if the disc supports it) or will be downsampled to
48kHz maximum. Some equipment can only support a 48kHz maximum
sample rate and hence it can be useful to set this maximum limit. CDs
are 16/44.1 so are unaffected.
ENGLISH
Go To Speaker Setup Page
-- Audio Setup Menu --
Speaker Setup
SPDIF Output RAW
LPCM Out 48K
HDMI Audio PCM
PRO Logic II
PPCCMM RRaaww
CCDD
PCM @ 16/44.1 PCM @ 16/44.1
DDVVDD-VV
Downmixed PCM Raw bitstream for
@ 16/48 or 16/96* surround sound
soundtracks
PCM @ 16/48 or 16/96*
for stereo soundtracks
DDIISSCC
SSEETTTTIINNGG
Menus Settings
Speaker Setup Downmix Stereo
Off
Front Speaker Large
Small
Centre Speaker Large
Small
Rear Speaker Large
Small
Test Tone On
Off
SPDIF Output SPDIF Off
RAW Bitstream
PCM Stereo
LPCM Out 48k
96k
HDMI Audio Follow SPDIF
PCM stereo
Pro Logic II Pro Logic II On
Off
PL II Mode Music
Movie