Filter
Top Products
55
6. Maintenance
6. Connect the supplied power cord, turn on the Main Power switch and turn on the projector.
7. Finally, select the menu
→
[Reset]
→
[Lamp counter] to reset the lamp usage hours.
NOTE: When the lamp exceeds 2100* hours (up to 3100* hours in Quiet mode) of service, the projector cannot turn on and the
menu is not displayed.
If this happens, press the INFO. button on the remote control for ten seconds to reset the lamp clock back to zero.
When the lamp time clock is reset to zero, the LAMP indicator goes out.
* LV-X6: 3100 hours (up to 4100 hours in Quiet mode).
2 cm/0.8"
5. Reattach the lamp cover.
(1) Place the lamp cover, leaving a space of about 2 cm/0.8" as shown on the drawing.
4. Insert a new lamp until the lamp is plugged into the socket.
CAUTION
Do not use a lamp other than the replacement lamp LV-LP26 (LV-7250) or LV-LP27 (LV-X6).
This may be ordered from your dealer.
Secure it in place with the two screws.
Be sure to tighten the screws.
(2) Slide the lamp cover back until it snaps into place.
• Make sure that the catches are aligned with slots.
• Push the lamp cover until it clicks into place.