Filter
Top Products
GB 29
GB
NO RETURN TO START-UP SCREEN WHEN DISC IS
REMOVED
• Check to see if the program requires another
disc to be loaded.
• Reset by unplugging the player from the power,
then connect the power again.
THE PLAYER DOES NOT RESPOND TO THE RE-
MOTE CONTROL
• Aim the remote control directly at the sensor on
the front of the player.
• Avoid all obstacles which may interfere with the
signal path.
• Inspect or replace the batteries.
NO AUDIO AT DIGITAL OUTPUT
• Check the digital connections
• Check the Digital Out menu to make sure that
the digital output is correctly set.
• Check if the audio format of the selected audio
language matches your unit capabilities.
THE DISC IS STUCK INSIDE THE PLAYER
• In case the disc is stuck inside the tray, please
switch off the unit, unplug the power cord and
wait for 2 minutes. The player will resume normal
operation after switching on.
NO TV/CABLE SIGNAL CAN BE RECEIVED
• Check the RF in/out cable connections on the
rear panel of the DVR.
• Please double check the In and Out directions
whether it was swapped or not.
• Tuner IN should be connected to Antenna or
Cable TV wall socket.
• Tuner OUT should be connected to TV.
• If power off the unit, the quality of TV/cable signal
will be degraded.
ALL CABLE TV CHANNELS LOOKS BAD
• You may have a HRC or IRC cable signal type.
• You need to change the cable type from STD to
HRC or IRC (see DVR Main Page - DVR Setup - TV
Cable Mode).
• Please do the auto channels search again after
changed the cable type.
WANT TO BACK TO FACTORY DEFAULT SETTINGS
AND ERASE ALL THE RECORDED PROGRAMS AS
WELL
• Reset the unit to factory default settings
• Then you need to redo Auto Channels Search
again
YOU HAVE FORGOTTEN THE PARENTAL PASSWORD
• You can set the DVR back to the factory default
settings and reset all your setup options with
the factory password 76418.
NO POWER
• Check if the on/off button on the front of the
player is set to on.
• Check if power plug of the mains cord is properly
connected.
• Check if there is power at the AC outlet by
plugging in another appliance.
NO PICTURE
• Check if the TV is switched on.
• Select the correct AV input on the TV
• Check the video connection between your DVR
and TV.
• Check if channel selector is set on AV on the TV.
(See your TV manual for instructions).
• Try the progressive/Interlace [I/P] key on your
remote control.
• Try to use normal video output (not S-Video or
YPrPb) and do the setup first.
DISTORTED PICTURE
• Check the disc for fingerprints and clean with
soft cloth, wiping from center to edge.
• Sometimes a small amount of picture distortion
may appear. This is not a malfunction.
COMPLETELY DISTORTED PICTURE
• The disc format is not according to the TV-set
used (PAL/NTSC).
• Check the Setup menu (See DVD Main Page -
Preferences - Video Output).
NO COLOUR IN PICTURE
• The disc format is not according to the TV-set
used (PAL/NTSC).
• Ensure DVD player is not connected through
VCR.
PICTURE SWING
• Relocated the unit further away from the
possible interference or emission source (e.g.
Radio, Power Amplifier, radiator etc.)
DISC CANNOT BE PLAYED
• Ensure the disc label is upwards.
• Clean the disc.
• Check if the disc is defective by trying another
disc.
NO SOUND
• Check the Audio cable connections between your
DVR and TV.
• Check the Audio Setup should be in Analog mode
(see DVD Main Page - Audio Setup - Audio out)
• If using a Hi-Fi amplifier, try another sound
source.
• Check that DTS is selected in the Audio menu if a
DTS disc is played.
DISTORTED OR B/W PICTURE
• The disc format does not match the TV-set used
(PAL/NTSC).
TROUBLESHOOTING - PROBLEM ?
If it appears that your unit is faulty, first consult this checklist. It may be that something simple has been
overlooked.
Under no circumstances should you try to repair the player yourself; as this will invalidate the warranty. Only
qualified service personnel can remove the cover or service this player.