Filter
Top Products
Setup
Q-Spot™ 160-LED User Manual Rev. 01b -7-
Gobo Wheel
The Q-Spot™ 160-LED comes equipped with a gobo wheel featuring seven rotating and
replaceable (slot-n-
lock system) gobos. The gobo wheel has an eighth position with no
gobo (open).
Gobo Wheel Diagram
Gobo
Replacement
The Q-Spot™ 160-LED features a gobo wheel that holds seven interchangeable, slot-n-
lock gobos. These gobos can rotate at various speeds and in both directions.
Follow the procedure below to change any of the gobos on the gobo wheel
Always disconnect the fixture from the AC power before opening it.
Procedure
1) Remove the gobo cover.
2) Remove the slot-n-lock gobo from the gobo wheel.
3) Using a small tool, pry the tension ring from the gobo holder.
4) Remove the old gobo.
5) Insert the new gobo, and replace in the reverse steps of removal.
If using coated glass gobos, make sure that the more reflective side of the gobo
(glass base) faces the light source. This way, the glass base of the gobo will
provide extra isolation to its coating from the heat of the light source, thus
minimizing the risk of damaging the gobo’s coating.
Gobo Replacement
Diagram
Gobo
Sliding knob
Gobo cover