Filter
Top Products
Setup
Q-Spot™ 160-LED User Manual Rev. 01b -5-
3. Setup
AC Power
This product has an auto-ranging power supply that can work with an input voltage
range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting the Q-Spot™ 160-LED to the proper voltage, as per
the specifications in this guide, the product’s manual or on the product’s sticker.
Always connect the Q-Spot™ 160-LED to a protected circuit with an appropriate
electrical ground to avoid the risk of electrocution or fire.
To determine the power requirements for the Q-Spot™ 160-LED
see the label affixed to
the side of the fixture. Alternatively, you may refer to the corresponding
specifications
chart in the Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download the “Sizing the Circuit Breakers” document
from the CHAUVET® Web site.
Never connect the Q-Spot™ 160-LED to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
The Q-Spot™ 160-LED comes with a power input cord terminated with an Edison plug
(US market). If the power cord that came with your fixture has no plug or you need to
change the Edison plug, use the table below to wire the new plug.
Connection Wire (US) Wire (Europe) Screw Color
AC Live Black Brown Yellow or Brass
AC Neutral White Blue Silver
AC Ground Green/Yellow Green/Yellow Green
Make sure to disconnect the fixture’s power cord before replacing a blown fuse,
and always replace it with a fuse of the same type and rating.
Fuse Replacement
1) With a flat head screwdriver, wedge the fuse holder out of its housing and remove
the blown fuse from its holder.
2) Replace the blown fuse with a fuse of the exact same type and rating.
3) Insert the fuse holder back in its place, and reconnect power.
The fuse is located
inside this compartment.
Remove it as instructed
above.
Power Input
On/Off Switch