Filter
Top Products
Operation
Q-Spot™ 160-LED User Manual Rev. 01b -9-
4. Operation
Control Panel
Description
Button Function
<MENU>
Exits from the current menu or
function
<ENTER>
Enables the currently displayed
menu or sets the currently
selected value in to the current
function
<DOWN>
Navigates downwards through
the menu list and decreases the
numeric value when in a function
<UP>
Navigates upwards through the
menu list and increases the
numeric value when in a function
Control Options
You can set the Q-Spot™ 160-LED start address in the 001~512 DMX range. This
allows for the control of up to 42 fixtures in the 12-channel Advanced DMX mode.
Programming
Carry out all the programming procedures indicated below from the control panel. Refer
to the Menu Map on page 13 to learn how the menu options relate to each other.
To go to an option, press <MENU> repeatedly until the option shows on the display.
To select an option value, press <UP> or <DOWN> until you see the desired value and
press <ENTER> to accept it.
To exit to the previous menu level, press <MENU>.
DMX Operation
1) Go to Intro > Run.
a) Select DMX-512.
b) Activate the DMX operation mode or return to the previous level.
2) Go to Intro > Address.
a) Select the starting address (001~512).
b) Activate the new DMX address or return to the previous level.
3) Go to Intro > Channels.
a) Select either Advanced (12 channels) or Basic (9 channels).
b) Activate the selected DMX mode or return to the previous level.
When selecting the Advanced mode, you can accommodate up to 42 Q-Spot™
160-LED fixtures on the same DMX universe.
Auto Programs
1) Go to Intro > Run.
2) Select Auto 1 or Auto 2.
3) Activate the selected AUTO program or return to the previous level.
Sound Programs
1) Go to Intro > Run.
2) Select Sound 1 or Sound 2.
3) Activate the selected SOUND program or return to the previous level.
Custom Program
1) Go to Intro > Run.
2) Select Custom.
3) Activate the CUSTOM program or return to the previous level.
See Edit Custom to learn how to configure the 255 steps of the CUSTOM program.
Continues on the next page