Chief Manufacturing PRO-2000 TV Mount User Manual


  Open as PDF
of 6
 
Installation Instructions
5
Figure 4
Figure 5
DISPLAY INSTALLATION
The following procedure assumes that the proper
interface bracket for the display being mounted has
already been installed on the display.
If no interface bracket is present on display, install
bracket to display using the instructions included with the
interface bracket before proceeding.
If an interface bracket for the display being mounted
needs to be obtained, or additional assistance is
required, contact a Chief Customer Service
representative by calling 1-800-582-6480 or by visiting
www.chiefmfg.com.
To install the display:
1. Two Q-latches are installed on this mount. Make sure
both Q-Latches are in the UNLATCHED position
(See Figure 6).
Figure 6
2. While supporting each side of the display, align the four
mounting buttons on the interface bracket with the four
teardrop slots in mount faceplate. Lower bracket firmly
into slots. (See Figure 7)
Figure 7
Wood Studs
(Right of Center Install)
Wood Studs
(Left of Center Install)
Wood Studs
Q-Latch
Faceplate
UNLATCHED
Faceplate
Display
Mounting
Button
Mounting
Button
Faceplate
Display
 previous