Filter
Top Products
English
Owner’s manual
TB741P/TB742P/TB743W 13
For your safety, the driver should not watch
the TV or operate the controls while driving.
Please note that watching and operating the
TV while driving is prohibited by law in
some countries. Also, while driving, keep
the volume to a level at which external
sounds can be heard.
Watching TV
1. Press the [BND] button to select TV1, TV2,
VTR1 or VTR2. Each time the [BND] button
is pressed, the setting is switched in the
sequence shown below.
CAUTION
TV Mode Operations
Auto store function
The channels received automatically are
automatically stored in the preset channels.
The setting procedure for the preset channels is
the same for TV1 and TV2.
1. Press the [PS] button for 1 second or longer,
the broadcast stations are automatically
stored in the memory starting with the one
following the station now received.
Seek tuning
Keep pressing the [a] or [d] button for about
1 second.
The seek tuning mode is selected. Tuning will
stop automatically at a channel where a
broadcast is received.
∗ When seek tuning has stopped before or after a
broadcast channel, press the [a] or [d] button
again.
Manual tuning
Press the [a] or [d] button to select the
channel.
The channel number appears at the top right of
the screen.
∗ Each time the [a] or [d] button is pressed, the
channel number is incremented or decremented
by 1.
∗ The channel number remains on the screen for
about 5 seconds.
Preset memory function
The number of preset channels which can be
stored in the memory is:
•6 stations for TV1
}
Total of 12 stations
•6 stations for TV2
Any station can be stored in any preset
channel.
TV1 TV2 VTR1 VTR2
A.STORE
F.WIDE
62
TV1
1
2
3
4
5
6
Notes:
• The signal conditions are sometimes such that a
channel without a station is stored in the memory.
• Some stations may not be stored if their signals
are too weak in the reception area.
• When a station could not be stored or a channel
without a station has been stored in the memory,
refer to the section on the manual memory
function which follows, and perform the settings
again.
Manual memory function
1. Press the [BND] button to select TV1 or
TV2.
2. Press the [MEMO] button, the manual
memory screen is displayed.
∗ While the channel display at the left of the
screen turns red, the manual memory
operation is available.
3. Press the [a] ro [d] button to select the
channel to be preset.
4. Press the [w] or [z] button to select the
preset channel in which the station to be
stored.
5. Press the [MEMO] button for 1 second or
longer to store the station into the preset
memory.
6. To cancel the manual memory mode, press
the [MEMO] button again and press the
[DISP] button.
Note:
• The memory contents are returned to the default
settings when the battery is replaced or the
power supply is otherwise suspended.