Filter
Top Products
Page 14 Coby Electronics Corporation www.cobyusa.com Page 15
Page 14 Coby Electronics Corporation www.cobyusa.com Page 15
Remote Control Battery Installation
Refer to the diagram. Remove the
battery compartment cover located
on the rear of the remote control. In-
sert batteries, making sure to match
their polarities (+/-) to the markings
on the inside of the compartment.
Replace the cover.
To use the remote, point it at the
remote sensor of the player. Oper-
ate the remote within 15 feet of the
sensor and at an angle of +/- 60 de-
grees.
Batteries in the remote will last for
approximately 1 year. Replace the
batteries if the remote control does
not work. Do not mix old with new
batteries, or different types of batteries.
Remove the batteries from the remote if it will not be used for a long period
of time.
The batteries used in the remote control may present a re or chemi-
cal burn if mistreated. Do not recharge, disassemble, incinerate, or
heat the battery (~212°F).
Keep batteries away from children.
•
•
•
•
GETTING STARTED
The remote control transmits a directional infrared beam. Be sure to aim
the remote control directly at the infrared remote sensor during opera-
tion. The sensor may not be able to receive signals properly if the sensor
is covered, if there is a large object between the remote control and the
sensor, or if it is exposed to direct sunlight or a strong articial light (e.g.,
uorescent or strobe lights). If possible, change the position of the light
source or reposition the unit to avoid direct lighting.