Filter
Top Products
Removal and Replacement Procedures
Maintenance and Service Guide 5–45
3. Remove the three TM2.5 × 5.0 screws
1
that secure the
charger board to the base enclosure (Figure 5-36).
4. Lift the front edge of the charger board shield
2
until it clears
the base enclosure, then slide the shield forward to remove it.
5. Lift up on the back edge of the charger board
3
to disconnect
it from the system board.
6. Remove the charger board from the base enclosure.
Figure 5-36. Removing the Charger Board
Reverse the preceding procedures to install the charger board.
272638-001.book Page 45 Thursday, July 25, 2002 4:21 PM