8
Chapter 2 :
Connecting an Antenna or Cable to Your TV
Antennas with two sets of leads
You might have two sets of leads from your antenna system, especially if you have
one antenna for VHF signals and one antenna for UHF signals.
If your antenna system has both a coaxial lead and twin 300-ohm leads,
you must obtain a combiner (available at your local electronics store). Press or screw
the coaxial lead onto the combiner; place the twin leads underneath the screws on the
combiner and tighten the screws. Press the cable from combiner onto the antenna ter-
minal on the back of your TV.
If your antenna system has two sets of twin 300-ohm leads,
you
must obtain a combiner (available at your local electronics store). Place one set of
twin leads underneath the screws on the combiner and tighten the screws. Do the
same with the other set of twin leads. Press the cable from the combiner onto antenna
terminal on the back of your TV.
Connecting a cable system
If your cable set-up is not described below, please contact your cable company for
more information.
If your cable system does not
require the use of a cable box,
simply
press or screw the incoming cable onto the
antenna terminal on the back your TV.