Filter
Top Products
ENGLISH
Daily Use
17
Daily Use
16
Programme Selection
The set has 100 programme numbers, PR00..PR99.
DIRECT SELECTION
The NUMBER buttons are used for direct programme selection.
To select a two-digit programme, press the second numbered button within 2 seconds.
UP/DOWN SELECTION
You can also select a programme by pressing step by step the UP/DOWN buttons.
Picture Control
1. Call up the Picture menu.
2. Select and adjust the level of each function:
“Brightness”, “Contrast”, “Colour”,
“Sharpness”.
The adjusted levels are stored automatically in
Favourite mode.
NOTE: Tint is displayed only when receiving a NTSC
signal.
Only Brightness and Contrast are displayed in
PC mode.
SMART PICTURE SELECTION
When you press the PICTURE button( )
repeatedly, you can call up four pictures settings;
Normal Bright Dark Favourite
Normal
Select Adjust Exit
Picture Brightness 75
Sound Contrast 50
Features Colour 30
Setup Sharpness 46
Tint 0
Zoom 16:9
-+
-+
-+
-+
-+
Switching On and Off
SWITCHING ON
1. If the Indicator is not lit, then the TV set is powered off.
You must press the /OFF button on the TV set.
The set will switch to stand-by mode and then the Indicator will illuminate in Red.
2. Press the /OFF button, UP/DOWN button or NUMBER button on the remote controller or
UP/DOWN button on the TV set.
The TV set will be switched on and then the Indicator will change to Green.
SWITCHING OFF
1.Press the /OFF button on the remote controller to return the set to its stand-by mode.
The Indicator will illuminate in Red.
2.Press the /OFF button on the TV set to switch the TV set off completely.
NOTE: If you don’t use the set for extended periods of time, unplug the AC cord from Power outlet.
Status
The STATUS button( ) is used to display the current
status; Mode (AV, Component, PC) and Signal
information for 2 seconds.
In TV mode, the Programme number and Station Name,
Sound mode are displayed.
AV1
PAL 50Hz/4.43MHz
PR 12 - - - - -
NICAM Stereo
DSL-15D1T PAL(‡» ˙ )GB 03.11.27 5:24 PM ˘ ` 16 mac001 1200DPI 80LPI