Filter
Top Products
Preparation
11
ENGLISH
Preparation
10
D-SUB JACK (PC RGB)
This jack has RGB inputs and is used to connect a PC.
Display mode
If the signal from the PC system equals one of the standard
signal modes, the screen will automatically adjust and display image.
If the signal from the PC system doesn’t equal any of the modes,
adjust the Video card setting on the computer. For the display modes
listed below, the screen image has been optimized during
manufacture. The message “Out Of Range” will appear when the PC
signal does not correspond to any of the below standard setting.
PC AUDIO INPUT JACK
Connect the stereo audio cable to the PC AUDIO jack and the other end to the Audio Out terminal of the Sound card
on your PC.
PC
1024X768 / 60Hz
Standard Resolution(Mode) V-frequency (Hz) H-frequency(kHz)
MAC 640x480 60 31.47
66 35.00
832x624 75 49.73
1024x768 60 48.78
75 60.24
IBM 640x350 70 31.47
640x480 60 31.47
720x400 70 31.47
VESA 640x350 85 37.86
640x400 85 37.86
640x480(VGA) 72 37.86
75 37.50
85 43.27
720x400 85 37.93
800x600(SVGA) 56 35.16
60 37.88
72 48.08
75 46.88
85 53.67
1024x768(XGA) 60 48.37
70 56.48
75 60.02
85 68.68
1280x768
(WXGA-only 17”)
60 47.70
TV/AV/PC MODE SELECTION
Press the AV( ) button on the control panel repeatedly to select the source,
TV AV1(or AV1/S-video) Component AV2(or AV2/RGB) PC TV
You can select the source direct using the TV, AV, COMP, PC button on the remote
controller. Press the AV button on the remote controller repeatedly to select AV1 or
AV2. In AV mode, you can change the TV programme number with the UP/DOWN
button or the NUMBER button.
NOTE : When the TV SET is no signal, OSD(On Screen Display) appears on the screen.
AV INPUT JACK (AV1)
This jack has video / audio inputs.
It is used to connect a VCR, Camcorder, DVD, STB, Video game.
S-VIDEO INPUT JACK (AV1/S-VIDEO)
It has Y/C inputs. This jack is used to connect S-Video equipment.
NOTE: The AV Audio input Jack and S-video Audio input Jack are shared
connections. So, you can not connect both the AV Audio Input cable and S-video
Audio Input cable. When the S-video Jack is connected, the TV set switches
automatically to AV1/S-video mode.
COMPONENT INPUT JACK (COMPONENT)
This jack has Y/Pb(Cb)/Pr(Cr) inputs and audio inputs.
It is used to connect a DVD.
SCART JACK (AV2, AV2/RGB)
This jack has video / audio inputs and outputs, RGB inputs.
It is used to connect a STB, VCR, DVD.
When the signal is RGB, the TV set switches automatically to
AV2/RGB mode.
In most cases, the TV set switches automatically to AV2(or AV2/RGB) mode,
when the external equipment connected is in playback mode. If not, then use
the AV button to select AV2(or AV2/RGB).
HEADPHONE JACK
Insert the headphone plug(3.5 mm ø) into this jack( ).
The sound from the speaker will be automatically cut off.
You can control the headphone sound with the LEFT/RIGHT button.
TV
PAL 50Hz/4.43MHz
AV1
PAL 50Hz/4.43MHz
AV1/S-video
PAL 50Hz/4.43MHz
Component
YUV 50Hz
AV2
PAL 50Hz/4.43MHz
DSL-15D1T PAL(‡» ˙ )GB 03.10.22 5:5 PM ˘ ` 10 mac001 1200DPI 80LPI