Dell SX2210 Flat Panel Television User Manual


  Open as PDF
of 37
 
Connecting the USB Cable
After you have completed connecting the DVI/VGA/HDMI cable, follow the procedure below to connect the USB cable to the computer and complete your
monitor setup:
1. Connect the downstream USB port (cable supplied) to an appropriate USB port on your computer.
2. Connect USB peripherals to the upstream USB ports on the monitor.
3. Plugthepowercablesforyourcomputerandmonitorintoanearbyoutlet.
4. Turn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not display an image, see Solving Problems.
5. Use the cable holder on the monitor stand to organize the cables.
Organizing Your Cables
After attaching all necessary cables to your monitor and computer, (see Connecting Your Monitor)usethecablemanagementslottoorganizeallcablesas
shown above.
Attaching the Soundbar (Optional)
To attach the soundbar:
NOTE: The graphics are used for the purpose of illustration only. Appearance of the computer may vary.
NOTICE: DonotusewithanydeviceotherthantheDellSoundbar.
1.
Working from the back of the monitor, attach Soundbar by aligning the two slots with the two tabs along the bottom of the monitor.
 previous next