Filter
Top Products
12
ENGLISH
(7) Connecting to a HDMI device
HDMI Terminal
This unit has one HDMI output. It can send digital video and analog signals from DVDs. It minimizes signal degradation caused
by analog conversion so that high quality images can be enjoyed.
Select an HDMI output mode from the SETUP MENU. (See page 23.)
NOTES:
• When the HDMI output is connected to a display monitor that does not support HDCP, signals are not output. To view
images in HDMI, it is necessary to connect to a display that supports HDCP.
• There may be no image output if connected to a TV or display that is not compatible with the above format.
• Refer to the instruction manual of the TV or display to be connected to the DN-V210/DN-V310 for detailed information
regarding the HDMI terminal.
* HDCP: High-bandwidth Digital Content Protection
CONNECTING HDMI DEVICES
An HDMI cable (sold separately) is used to connect the HDMI output on the DN-V210/DN-V310 with the HDMI Terminal on a
DVD player, TV, projector or other component. To transmit multichannel audio via HDMI, the connected player must support
multichannel audio transmission through its HDMI output.
HDMI video streaming is compatible with DVI in principle. Therefore, it is possible to connect to a TV or monitor that has a DVI
terminal using an HDMI-DVI conversion cable or plug. When connecting to a DVI terminal, connect the audio signal separately.
Note that HDCP may not work with some DVI components.
HDMI SPECIFICATIONS
The HDMI output supports the High-Definition Multimedia Interface specification Information version 1.0.
The video resolutions are as follows.
• 480 p : 720 × 480
• 720 p : 1280 × 720
• 1080 i : 1920 × 1080
If the connected HDTV on projector doesn’t support a resolution, HDMI output resolution may not work.
The audio formats are as follows.
• PCM (41.1 kHz, 48 kHz, 96 kHz)
• Dolby Digital
• DTS
If your TV only supports HDMI digital audio up to 48 kHz, change the Linear PCM out setting to down sample on. (See page
27.)
If your TV doesn’t support Dolby Digital, set the digital out setting to PCM. (See page 26.)
If your TV doesn’t support DTS, the DN-V210/DN-V310 will not be able to play DTS format audio sound tracks. In this case, on
your DVD-video discs audio set up menu, select an audio format other than DTS.