Filter
Top Products
25
Advanced operations
123
456
789
0
S
10
6:9 5
∫;
1
PLAY MODE
REPEAT MODE
A-B REPEAT
V.S.S.
SET UP CLEAR
SUBTITLE AUDIO ANGLE
RETURNDISPLAY
ENTER
MENU
SLOW/SEARCH
PLAY
OPEN/CLOSEPOWER
STILL/PAUSESTOP
– SKIP –
TOP MENU
REMOTE CONTROL UNIT
RC-550
ENTER
3, 4, 2, 1
ENTER
Changing initial setting
[DVD]
Digital output
Refer also to “Common procedures” (ápage 21) and the “Audio
menu” section in “Summary of initial settings” (ápage 22).
PCM Down Conversion
No (Factory preset):
When you have connected an amplifier with audio cables.
Yes:
When you have connected an amplifier with an optical digital audio
cable.
Copyright protection limits digital output to 48 kHz/16 bit.
When playing DVDs recorded in 96 kHz
Sound is output as follows in accordance with the connections and
settings you have made.
¤1
The connected equipment must be able to handle 96 kHz LPCM in
order to take advantage of high quality audio found on these discs.
Dolby Digital
Bitstream (Factory preset):
When you have connected a unit with a built-in Dolby Digital decoder.
PCM:
When you have connected a unit that doesn’t have a built-in Dolby
Digital decoder.
¤2
DTS Digital Surround
Off (Factory preset):
When you have connected a unit that doesn’t have a built-in DTS
decoder.
¤2
(No digital signal is output.)
Bitstream:
When you have connected a unit with a built-in DTS decoder.
¤2
These changes to digital audio output must be made, other-
wise bitstream signals the decoder cannot handle will be out-
put. If these signals are output, “noise” will be output which
can cause harm to your ears and speakers.
Connection
Setting
No
Yes
Analog
Output as
96 kHz
Converted and
output as 48 kHz
Digital
No output (If there is no
copyright protection, audio is
output at 96 kHz.
¤1
)
Converted and output as
48 kHz/16 bit