Filter
Top Products
27
© 2002 directed electronics, inc.
step 10
Testing the system
Once steps 1-9 have been completed, the operation of the
system can be tested.
Place the two 30-amp fuses back into the relay satellite RED
wire fuse holders. Make sure that the vehicle is in park with the
emergency brake on and the hood closed. Press and on
the remote control simultaneously to initiate the remote start
function. The parking lights should flash to confirm the remote
start command has been received, The accessories and ignition
should turn on followed by the starter cranking and the vehicle
engine running. Pressing and again simultaneously will
shut the engine off.
ttrraannssmmiitttteerr ffuunnccttiioonnss
The receiver uses a computer-based learn routine to learn the
transmitter buttons. This makes it possible to assign any specific
transmitter button, or combination of buttons, to any receiver
function. The transmitter initially comes programmed in the
Standard Configuration, but may also be customized by an
authorized dealer. Unless otherwise specified, the buttons used
in all of the instructions in this manual correspond to a Standard
Configured transmitter.
➜