Filter
Top Products
30
© 2002 directed electronics, inc.
3.
TTrraannssmmiitt..
While holding the Program
switch, press the button on the transmitter
that you would like to control the selected
receiver channel.
4.
RReelleeaassee..
Once the code is learned, the
Program switch can be released.
You can advance from programming one channel to another by
releasing the Program switch and tapping it to advance steps and
then holding it. For instance: You have programmed Channel
One and you want to program Channel Two. Release the
Program switch. Press it one time and release it to advance from
Channel One to Channel Two. Now, press and hold the
Program switch. The LED will flash two times. As before, do not
release it.
If you want to program Channel Three after programming
Channel One, release the Program switch, press it twice and
release it to advance to Channel Three. Then press it once more
and hold it. The LED will flash three times to confirm it is ready
to receive the code from the transmitter.
Learn Routine will be exited if:
➤ Ignition is turned off.
➤ Program switch is pressed too many times.
➤ More than 25 seconds elapses between programming steps.