34
© 2002 directed electronics, inc.
The engine will shut down and the parking lights will flash four
times. The engine will then restart to confirm that Timer Mode
has been entered.
The engine may be allowed to run for its preset time or can be
shut down by pressing Buttons and again. Either way, it
will restart every three hours for a total of six cycles. If the unit
receives a shutdown input while operating in the timer mode the
engine will stop, but will restart, on schedule, again in three hours.
To exit Timer Mode:
Timer Mode can be exited by turning the ignition on with the
key any time the engine is not running. You can also exit Timer
Mode manually from the transmitter by following these steps:
1. Start the engine by pressing and .
2. Press and release .
3. Within two seconds press and release and again.
4. The engine will shut down and the parking lights will flash
four times to confirm that Timer Mode has been exited. If
the car has already been remote started, skip Step One.
valet take-over
The Valet® Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
➜