Filter
Top Products
PROGRAMMING OTHER COMPONENT CONTROLS
The
AV1
and
AV2
switch position can be used to program a
VCR, DVD, STEREO, 2nd DIRECTV Receiver or 2nd TV with
the following instructions.
1. Turn on the component (e.g. DVD Player) you wish to
program.
2. Locate the 5-digit code for your component (see pages
13-22).
3. Move the slide switch under the
AV1
(or
AV2
) icon.
4. Press and hold the
MUTE
and
SELECT
keys at the same
time until the green light under
AV1
(or
AV2
) flashes
twice and then release both keys.
5. Using the number keys enter the 5-digit code for your
brand of component being programmed. If performed
correctly the green light under TV will flash twice.
6. Aim the remote at your component and press the power
key once. The component should turn off. If it does not
turn off, repeat steps 3 and 4 trying each code for your
brand until you find the correct code.
7. Repeat steps 1 through 6 to program a new component
under
AV2
(or
AV1
).
8. For future reference write down the working code for
the component(s) programmed under
AV1
and
AV2
in
the blocks below:
AV1:
COMPONENT:
AV2:
COMPONENT:
12
DirecTV-M2081A.qxd 12/22/2004 3:45 PM Page 12