Filter
Top Products
SEARCHING FOR YOUR CODE IN AV1 OR AV2
MODE
If you were unable to find the code for your brand of TV or
component, then you can try a code search. This process may
take up to 30 minutes.
1. Turn on the TV or component.
2. Move the slide switch to the
AV1
,
AV2
or
TV
position.
3. Press and hold the
MUTE
and
SELECT
keys at the same
time until the green light under the selected switch posi-
tion flashes twice and then release both keys.
4. Enter in
9-9-1
followed by one of the following 4-digits:
COMPONENT TYPE COMPONENT ID #
Satellite 0
TV 1
VCR/DVD/PVR 2
STEREO 3
6. Point the remote at the TV or component and press
CHAN
S. Repeatedly press the
CHAN
S until the TV or
component turns off.
Note: Every time
CHAN
S is pressed the remote advances to the
next code and power is transmitted to the component
7. When the TV or component turns off, stop pressing the
CHAN
S key. Then, press and release the
SELECT
key.
NOTE: If the light flashes 3 times before the TV or component
responds, then you've cycled through all codes and unfortunately
the code you need is not available. You must use the remote that
came with your TV or component.
VERIFYING THE CODES
If you have setup the DIRECTV Universal Remote Control
using the SEARCHING FOR YOUR CODE PROCEDURE, you
can find out the 5-digit code your component responded to
with the following instructions:
1. Move the slide switch to appropriate position.
2. Press and hold the
MUTE
and
SELECT
keys at the same
time until the green light under the selected switch
flashes twice and then release both keys.
3. Enter in
9-9-0
(The green light under the selected
switch position will flash twice)
4. To view the first digit in the code, Press and release the
number 1 key. Wait three seconds, and count the num-
ber of times the green light flashes. Write this number
down in the leftmost TV, AV1 or AV2 code box found
on pages 11 or 12.
Note: If this part of the code is "0" the light will not flash
23
DirecTV-M2081A.qxd 12/22/2004 3:45 PM Page 23