DirecTV ProScan DSS Receiver Satellite TV System User Manual


 
Reference
66
After you program the remote to control
your VCR, record your VCR code here
for easy reference.
Programming the Remote to Control
Your TV
To determine whether your remote needs to be programmed, turn the
TV on, point the remote at the TV, and press the TV button. Then press
CHAN UP or DOWN to see whether the TV responds to the remote
commands.
Follow these steps to program your remote to control your TV.
1. Turn on the TV.
2. Look up your brand and code number(s) on the TV Code list on the
following pages.
3. Press and hold the TV button.
4. Enter the three-digit code from the code list.
5. Release the TV button and press OFF•ON or CHAN UP/DOWN to
see if the TV responds to the remote commands. If it doesn’t, try
the next code listed for your brand.
6. Repeat these steps until the TV responds to the remote commands.
Programming the Remote to Control
Your VCR
To determine whether your remote needs to be programmed, turn the
VCR on, point the remote at the VCR, and press the VCR button. Then
press POWER or CHAN UP or DOWN to see if the VCR responds to
the remote commands.
Follow these steps to program your remote to control your VCR:
1. Turn on the VCR.
2. Look up your VCR brand and its code number on the code list on
the following pages.
3. Press and hold the VCR button.
4. Enter the three-digit code from the code list.
5. Release the device button and press POWER or CHAN UP/
DOWN to see if the VCR responds to the remote commands.
6. Repeat these steps using the next code listed for your brand until
the VCR responds to the remote commands.
This remote may not operate all models
of the brands that are shown. Use the
codes shown in this manual, or on the
sheet packed with your remote.
After you program the remote to control
your TV, record your TV code here for
easy reference.
This remote may not operate all models
of the brands that are shown. Use the
codes shown in this manual, or on the
sheet packed with your remote.