Filter
Top Products
5
SETTING UP TO CONTROL THE SATELLITE
R
ECEIVER
The remote and the receiver must be set up on the same address so that
the remote can control the receiver. When you get the remote, it's
already set up to control the receiver on address 1. However, your
receiver may be set to a different address or, in the case of the DISH
Player-DVR 522, may need some additional setup. To set up the
remote and receiver to work together on the same address, use the
following instructions.
5. If you are converting the remote
to operate like a second UHF
Pro remote to control the
side of the DISH Player-DVR
522 receiver, then get the green
1 UHF Pro key provided
separately. Install this key in the
remote with the UHF Pro
marking showing.
If you set up your DISH Player-DVR 522 to
operate the side using UHF Pro, the two
UHF Pro remotes for this receiver will interfere
with each other when operated at the same time.
This may prevent the remotes from operating
the receiver momentarily.
6. If you have not already installed batteries, install them now.
See Installing Batteries for further details.
7. Slide the battery cover back into place.
Note: Key has the
UHF Pro marking.
text_dishpvr.fm Page 5 Tuesday, March 2, 2004 12:35 PM