Filter
Top Products
Basic Operation
Turnin
g
off the Pro
j
ector - Procedure
1.
Press the power button on the projector or remote control. The
powe
r off confirmation message appears .
2.
Press the power button again and the projector will enter cool-down
mode. The lamp shuts off, the lamp indicator flashes red, and the
fans continue to run for approximately two minutes. During the cool
down sequence the projector will not respond to any control panel
or remote control buttons.
Do not set the power switch to off or unplu
g
the
projecto
r during the cool-down sequence. Not allowing
the lamp to cool properly will greatly reduce the life
of the lamp.
CAUTION
3.
After the cool-down sequence is completed the fans will shut of
f
and the lamp indicator will stop flashing. The projector is now in
standb
y mode and can be turned back on with the remote control
or con
trol panel. If the projector will not be used for an extended
period, set the power switch to off and disconnect the power cord.
31