Filter
Top Products
4
Installing and removing the standDX-40L150A11
Installing and removing the
stand
You must install your TV into the stand in order for it to stand upright on
a cabinet or other flat surface. If you intend to mount your TV on a wall
or other vertical surface, you must remove the stand column.
Cautions
• Read these instructions carefully before you try to assemble the
stand or remove the stand column.
• Make sure that you handle the TV carefully when attempting to
assemble or remove the stand. If you are not sure of your ability
to do this, contact a professional installer or service technician.
Dynex is not responsible for any damages or injuries that occur
because of mishandling or incorrect assembly.
• Use a soft cushion or covering to prevent scratching or damage to
the TV screen or cabinet.
• Before assembly or removal of the stand, unplug the power cord.
Installing the stand
To install the stand:
1 Remove the stand from the box and place it on a table or bench.
2 Lay the TV on a flat, cushioned surface.
3 Align the stand with the TV, as shown in the following
illustration.
4 Secure the stand to the column with the four screws provided.
Installing a wall-mount bracket
To install a wall-mount bracket:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2 Remove the four screws that secure the TV to the base, then
remove the base.
3 Remove the four screws holding the stand bracket to the TV, then
remove the stand bracket.
4 Secure the wall-mount bracket to the back of your TV using four
M6 screws (not provided).
Caution: You must be mindful of the length of the screws used to mount
the wall mount bracket to the back of your TV. The screws must be
10-12 mm in length. Using shorter screws could result in an insecure
mount. Using longer screws could cause a space between the wall
mount bracket and the TV.
200 mm
200 mm
M6 screws
DX-40L150A11_10-0017.book Page 4 Tuesday, February 16, 2010 4:15 PM