Filter
Top Products
10
Making connectionsDX-42E250A12
Using coaxial (good)
To connect a cable or satellite box using coaxial:
1 Turn off your TV and all connected equipment.
2 Connect the incoming cable from the cable wall jack to the
cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not included) to the ANT/CABLE IN jack
on the side of your TV and to the coaxial out jack on the cable or
satellite box.
4 Turn on your TV, then turn on the cable or satellite box.
5 Go through the setup wizard on page 16.
Connecting an antenna or cable TV (no
box)
To connect an antenna or cable TV (no box):
1 Turn off your TV and all connected equipment.
2 Connect a coaxial cable to the ANT/CABLE IN jack on the side of
your TV and to the antenna or cable TV wall jack.
3 Turn on your TV.
4 Go through the setup wizard on page 16.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
Cable or
satellite box
Side of TV
Coaxial cable
From cable TV
wall jack (75 ohm)
To Cable-in jack on the
cable TV or satellite box
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
Side of TV
Coaxial cable
DX-42E250A12_11-0618_MAN.book Page 10 Wednesday, August 31, 2011 8:31 AM