Filter
Top Products
6
Installation instructionsDX-TVM113
STEP 2 - Option 2: Installing on a solid concrete* or concrete block wall
CAUTION:To prevent property damage or personal injury, never drill into mortar between blocks. Mount wall plate
directly onto the concrete surface.
1 Align the wall plate template (R) at the height you determined in the previous step, make sure that it is level,
then tape it into place. Use a pencil to mark the lag bolt hole locations (4). Remove the wall plate template.
2 Drill pilot holes to a depth of 2.5 in. (63.5 mm) using a 1/2 in. (13 mm) diameter masonry drill bit.
3 Insert the concrete wall anchors (Q) into the pilot holes and use a hammer to make sure the anchors are flush
with the concrete surface.
4 Align the wall plate (A) with the anchors, insert the lag bolts (P) through the lag bolt washers (O), then
through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate.
CAUTION:
• Avoid potential injuries or property damage!
• DO NOT over-tighten the lag bolts (P).
.
You’ll need
R
2.5 in.
(63.5 mm)
* Minimum solid concrete thickness: 8 in. (203mm)
* Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm).
* Minimum horizontal spacing between fasteners cannot be less
than 16” (406 mm).
P (4)
Drill
1/2" masonry
drill bit
1/2" socket
wrench
Level
Q (4)
Hammer
Wall plate (A)
Pencil
O (4)
DX-TVM113 Wall Plate Template • Gabarit • Plantilla
Note: For wood frame installations, use a stud nder to locate wood
studs rst.
Remarque : Pour une construction à ossature de bois, localiser
d'abord les montants en bois, à l'aide d'un détecteur de montants.
Nota: para la instalación en construcciones de armazón de madera,
primero debe localizar las vigas de madera con un localizador de vigas.
http://san.us/286
Need more information about your mount? Scan this QR code or visit www.dynexproducts.com.
<FR>Need more information about your mount? Scan this QR code or visit www.dynexproducts.com.
<SP>Need more information about your mount? Scan this QR code or visit www.dynexproducts.com.
Tools Needed
Outils nécessaires
Herramientas requeridas
Top
Haut
Parte superior
Top
Haut
Parte superior
V1 13-0140
Wall plate template (R)
Tape
DX-TVM113_13-0321_MAN_V2_EN.fm Page 6 Friday, April 26, 2013 11:11 AM