Filter
Top Products
1080p Upconvert DVD Player
23
Cleaning discs
Fingerprints and dust on the disc can cause poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe the disc from the center out.
Do not use strong solvents such as alcohol, benzine, thinner, commercially available cleaners,
or anti-static spray intended for older vinyl records.
Note: Never operate this player immediately after moving it from a cold location to a warm
location. Leave it for two or three hours without operating it. If you use this product in
such a situation, it may damage discs or internal parts.
Resetting your player
Reset your player if you observe any of the following symptoms:
• When your player is plugged in, but the power will not turn on or off.
• When the display window is not working.
• When your player does not operate normally.
To reset your player:
• Unplug the power cord for 30 minutes, then plug in the power cord again. This
should reset your player.
Specifications
System and outputs
VF Signal system NTSC
Frequency response CD: 20 Hz~20 KHz (EIAJ)
DVD: 20 Hz~44 KHz (96 KHz)(Sample result)
20 Hz~22 KHz (48 KHz)(Sample result)
Audio S/N ratio > 90 dB
Audio
MPEG LAYER2 standard
Audio output (analog audio)
Electric level output: 1.8 ± 0.2 V Resistance: 10 Kohm
Audio output (digital audio)
Electric level output: 0.5 V p-p Resistance: 75 ohm
DX-UPDVD2 09-0463_MAN_ENG_V1.fm Page 23 Tuesday, July 14, 2009 9:20 AM