Filter
Top Products
USING THE PROJECTOR
TO TURN ON THE PROJECTOR
Connect the projector to a video source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the
appropriate terminals on the side of the projector (See “CONNECTING THE PROJECTOR” section on pages 9-16).
Connect the projector’s AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the side of
the projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will light
GREEN.
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector to ON. The LAMP POWER indicator light will dim and the cooling fans will
operate, The count-down display appears on the screen and the count-down starts (30-
29-28-...1). The signal from the video source appears after 30 seconds.
CAUTION:
THIS PROJECTOR USES A METAL-HALIDE ARC LAMP. TO EXTEND THE LIFE OF THE
LAMP, ONCE YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING
IT OFF.
NOTE: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.
Wait at least 5 minutes before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continues to flash, follow the procedures below:
(1). Press LAMP POWER ON/OFF button to OFF.
(2). Check the air filter for dust accumulation.
(3). Remove dust with vacuum cleaner (See “AIR FILTER CARE AND CLEANING” section on page 50.)
(4). Press LAMP POWER ON/OFF button to ON.
If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or
service station.
TO TURN OFF THE PROJECTOR
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector. The “Power off ?“ appears on the screen. Press again the LAMP POWER
ON/OFF button to turn OFF the projector. The LAMP POWER indicator will light
bright and READY indicator will turn off. The cooling fans will operate for 1 minute
after the projector is turned off. (During this “cooling down” period, the projector
cannot be turned on.) The READY indicator will light green again and the projector
may be turned on by pressing the LAMP POWER ON/OFF button. To power down
completely, turn the MAIN ON/OFF switch (located on the side of the projector) to the
OFF position.
DIRECT OPERATION
MODE SELECT
Press the MODE button (located on remote control unit or on the projector) to select
Computer 1, Computer 2, Video 1 or Video 2 Input. The “Computer 1”, “Computer 2”,
‘Video 1” or “Video 2” display will appear on the screen for a few seconds.