Filter
Top Products
PC ADJUSTMENT
This projector can automatically detect the most display signals in most personal computers currently existing in the market.
However, some computers output a special signal format which is different from the standard ones and may not be detected by
this projector. If this case happens, the projector cannot reproduce a proper image, often recognized as a flickering picture, a non-
synchronized picture, a non-centered picture or a skewed picture.
To project a proper image for those non-standard formats, this projector provides PC ADJUST, in which you can precisely adjust
several parameters to match the input signal format. The projector has eight independent memory areas that you can store the
parameter settings you have made. Therefore, you can recall the setting for a specific computer when you need it.
1. Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear.
2. Press the POINT LEFT/RIGHT BUTTON(s) to select PC ADJUST and press the SELECT (REAR CLICK) BUTTON.
Another dialog box” Where to reserve” will appear.
3. In this dialog box, you will select one of the memory areas shown as “Mode 1” to “Mode 8”. If the parameters have been
previously set and stored to the memory, the status “Stored” will appear on a corresponding row. If not, “Free” will appear.
4. Press the POINT DOWN BUTTON and a red arrow will appear.
5. Move the arrow to one of the “Modes” (Free position) that you want to store by pressing the POINT UP/DOWN BUTTON(s).
Press the SELECT (REAR CLICK) BUTTON to select it.
NOTE; If all modes are occupied, no new PC parameter data can be stored. In this case, clear the PC parameter data using the
Mode free Function.