Filter
Top Products
25
8. Maintenance and service
Change the module lamp immediately when the lamp life reaches 1500 hrs to
maintain the best projection image.
8.1 Replacing the lamp module
When the lamp is within 30 hours of maximum lamp life, projector will display a
warning automatically stating, “Lamp has reached its end of life! Lamp
replacement is suggested!”. When this message appears, please change the lamp
immediately.
To replace the lamp module:
1. Turn off the projector and wait for the fan to stop.
2. Turn off the main power switch, and disconnect the power cord and all cables.
3. Let the projector lamp cool down completely (approximately 30 minutes).
4. Use screwdriver to loosen the screws of lamp access panel and lamp module.
5. Take out the lamp module.
6. Gently process the new lamp module into the lamp bay, then replaces the lamp
module retaining screws.
7. Replace the lamp bay access panel, and then replace the access panel screw.
Use screwdriver to loosen the lamp access
p
anel screws, and then press down the access
p
anel lock to remove the access
p
anel.
Remove the three lamp module
retaining screws, unsnap the
lamp removal handle to change
the lam
p
module.