Filter
Top Products
2 13
Battery installation (Remote Control)
The remote control requires one
"button-type" 3-volt lithium battery,
included. To extend the life of the
original battery we have inserted
a small clear plastic spacer tab
between the lithium battery and the
battery terminal.
You must remove this battery spacer
tab before you can use the remote
control.
To remove the tab, pull it in the
direction of the arrow in the illustration
as shown.
When the operation of the remote control becomes intermittent
or unsatisfactory, replace the original battery with a new 3-volt
lithium battery.
The battery number is (CR2025) or equivalent.
To replace the battery, remove the screw at the back of the
remote control with an appropriate screwdriver and open the
battery cover.
Remove the original battery from the battery compartment and
install a new (CR2025) battery with the " + " side facing up as
shown in the illustration. Then put the battery cover and screw
back to its original place.
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Dispose of the original battery properly. It should not be
thrown into a fire as the battery may explode if incinerated.
It should not be left around where small children or pets
might play with, or swallow it. If the battery is accidentally
swallowed, contact a physician immediately.
California Use Only:
The Perchlorate warning applies only to primary
CR(Manganese Dioxide) Lithium coin cells sold or distributed
ONLY in California,USA. "Perchlorate Material-special
handling may apply." See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Installation
This section describes how to connect the system to a TV monitor with audio/video input jacks. You cannot connect this system
to a TV monitor which does not have a video input connector. Be sure to turn off the power of each component before making
the connections.
Unpacking
Check that you have the following items:
• Main unit (1).
• Remote control (1).
• Audio/Video cable (4 feet x 1).
• Owner’s Manual (1).
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent
the product from moving when you operate the controls.
These 'feet' are made from non-migrating rubber material
specially formulated to avoid leaving any marks or stains on
your furniture. However certain types of oil based furniture
polishes, wood preservatives, or cleaning sprays may cause
the rubber 'feet' to soften, and leave marks or a rubber
residue on the furniture. To prevent any damage to your
furniture we strongly recommend that you purchase small
self-adhesive felt pads, available at hardware stores and
home improvement centers everywhere, and apply these
pads to the bottom of the rubber 'feet' before you place the
product on fine wooden furniture.
Remove
before use
BARBIE BAR330_Eng P13-26.p65 2/2/2007, 3:30 PM13