Filter
Top Products
–
15
–
EN
–
15
––
15
––
15
––
15
––
15
–
DEGAUSSING
This television has a degaussing circuit that will clear
up color errors on the TV screen that are caused by
any excess magnetism which happens to get too close
to the TV. This circuit is designed to operate once
when the set is first plugged in. If minor color
errors are seen in some locations on the screen,
please unplug the TV for approximately 30 min-
utes. When the TV is plugged back in, the degauss-
ing circuit will operate once to clear them up. Repeat
this procedure any time the TV screen is accidentally
magnetized or when the TV is moved or relocated.
TV
sB
BRIGHT to decrease to increase
brightness brightness
CONTRAST to decrease to increase
contrast contrast
COLOR to pale to brilliant
TINT to purple to green
SHARPNESS to soft to clear
PICTURE CONTROL
The unit’s picture controls – BRIGHT, CON-
TRAST, COLOR, TINT and SHARPNESS – are
preset to factory specifications. Although they are
usually the best, you may need to make some further
adjustments for a natural looking image.
Make sure ...
•
The unit must be turned on.
1 Select “PICTURE CONTROL”
Hit
[PICTURE].
2 Select item you want to adjust
Press [K / L] until desired control is displayed.
BRIGHT
CONTRAST
COLOR
TINT
SHARPNESS
3 Adjust the picture control
Press [s / B] to adjust to your desired level within
5 seconds.
NOTE:
•
At step 3, the picture adjustment display will dis-
appear from the TV screen after about 5 seconds
unless you press any buttons, even though you may
not be finished. In this case, repeat from step 1.
TV
•
If there is a power failure of any kind, the unit will
retain its memory for this feature.
BRIGHT
–
PPPPPPPPPPPPPPCCPPPPPPPPPPPPPP
+
The Sleep Timer function turns off the unit without
using [POWER] after a desired period of time.
1 Call up the Sleep Timer Setting
Hit [SLEEP] so that “SLEEP TIMER” appears.
2 Set sleep time
Hit [SLEEP] repeatedly until your desired sleep time
appears.
Each additional hit will increase the
time by 30 minutes up to 120 min-
utes.
After 5 seconds, the Sleep Timer
setting will disappear automatically.
NOTE:
•
When you disconnect the unit from the AC outlet,
or if you have a power failure, the sleep time will
be lost.
•
To confirm the time left for sleep timer, hit
[SLEEP] once and the display appears for 10 sec-
onds.
TO CANCEL THE SLEEP TIMER
Hit [SLEEP] to call up the Sleep Timer Setting. Hit
[SLEEP] repeatedly until “SLEEP 0 MINUTES”
appears.
TV
SLEEP 120 MINUTES
SLEEP TIMER