Filter
Top Products
- 12 - EN
1C29
TO RECORD A SCRAMBLED/UNSCRAM-
BLED CHANNEL
1.Set the unit’s channel selector to the output channel
of the Cable Converter Box or Satellite Box (Ex.
CH3).
2.Select the channel to record from your Cable
Converter Box or Satellite Box.
INSTALLING THE BATTERIES
1)Open the battery compartment cover by pressing
the cover on the remote unit in the direction of the
arrow.
2)Insert 2 “AA” penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3)Replace the cover.
EXTERNAL INPUT MODE
When using an external input signal (another VCR or
video camera), connect the player’s audio/video out-
put cables to the AUDIO L/R IN/
VIDEO IN jacks of your unit. Then
press the CHANNEL button K or
L until “AUX” appears on the
screen.
AUX
Note to CATV system installer:
This reminder is provided to call the CATV sys-
tem installer’s attention to Article 820-40 of the
NEC that provides guidelines for proper ground-
ing and in particular, specifies that the cable
ground shall be connected to the grounding sys-
tem of the building as close to the point of cable
entry as practical.
CONNECTING TO EXTERNAL
INPUT JACKS
When you watch a program recorded on another
source (VCR or video camera), use the AUDIO/
VIDEO input jacks on the front panel.
Connect the audio/video output jacks of another
source to the AUDIO L/R and VIDEO jacks of this
unit.
Then press the CHANNEL button
K or L until
“AUX” appears on the screen.
NOTE:
•
When you connect a monaural VCR (another
source) to this unit, connect the Audio output jack
of the monaural VCR (another source) to the
AUDIO L jack of this unit. The audio will output
in both L and R channel equally.
[Another source]
To the audio
output jacks
Audio/Video
cable
(not supplied)
etc.
To the video
output jack
[Front of the unit]
[Fig. 5]
T0052UC(p1-35).QX3 04.9.16 2:13 PM Page 12