Installation 3-1
3
Installation
This chapter provides the instructions to install the 5H102-48 or 5H103-48 module. A Phillips
screwdriver is required to install options into the module. Follow the order of the sections listed
below to correctly install the module.
• Unpacking the Module (Section 3.1)
• Installing the Module into the 5C105 MATRIX E5 Chassis (Section 3.2)
• Connecting to the Network (Section 3.3)
• Completing the Installation (Section 3.4)
3.1 UNPACKING THE MODULE
Unpack the module as follows:
ELECTRICAL HAZARD: Only qualified personnel should install the module.
NOTE: Read the Release Notes shipped with the module to check for any exceptions to
the supported features and operation documented in this guide.