Filter
Top Products
Using LANVIEW
4-4 Troubleshooting
TX
(Transmit)
Off Port enabled, and no
activity.
Should flash green every
two seconds indicating
BPDUs being sent if STA
is enabled and there is a
valid link.
1.Ensure that the STA is enabled and that
there is a valid link.
2.Contact Enterasys Networks for
technical support.
Green Flashing. Indicates
activity. Rate indicates
data rate.
None.
Amber Blinking. Port may be
disabled due to Spanning
Tree.
1.Ensure that the port is not disabled.
2.Contact Enterasys Networks for
technical support.
Red Flashing. Indicates
collision rate.
None, unless there is a high amount of
activity. In this case, check for network
configuration problems or a defective
device.
Solid. Diagnostic failure. Contact Enterasys Networks for technical
support.
Speed Off Port is in 10 Mbps
(10BASE-T).
None.
Green Solid. Port is in 100 Mbps
(100BASE-TX).
None.
Table 4-1 LANVIEW LEDs (Continued)
LED Color State Recommended Action