Filter
Top Products
54
4.4.4 Alarm-G-Sensor Settings
Figure 4-20 Alarm – G-Sensor
G-Sensor: Select On to enable G-Sensor function. Select Off to disable G-Sensor function.
XY Axial Trigger Value: Set XY Axial trigger value, alarm will be triggered when acceleration reaches this
value in horizontal direction with respect to the horizon.
Z Axial Trigger Value: Set Z Axial trigger value, alarm will be triggered when acceleration reaches this
value in vertical direction with respect to the horizon.
Alarm Output: This will transmit a signal through the alarm output relay. It can be set to either “NONE” (not
active), “1” (active) or “2” (active).
Output Type: Output action when alarm is triggered.
Timeout: Alarm output lasts for the set time duration.
Permanent:
Alarm will be continuously active until user presses “Enter” key.
Transparent: Alarm output remains active until event ends.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.
Timeout Duration: The amount of time the buzzer sounds when GPS is lost. Duration selectable from 1 to
150 seconds.
Pre-alarm Record: Check box to start copying recorded video to the hard disk from 5 seconds before the
video loss. (Pre-alarm recording rate will follow the “Normal” frame rate setting)
Email Notify: Check box to enable email notification when GPS is lost. Email operation requires that valid
email settings have been entered in the Network Setting/Email setup screen.
Network Alarm: Check box to send out a network alarm to client PC. (requires PowerCon software and
setting up Alarm Server in Network Setup menu)
Click
button to return to the previous level of menu.