Filter
Top Products
EDID 101D/EDID 101V • Installation and Operation
Installation and Operation, cont’d
10
EDID 101D/EDID 101V Operation
The EDID 101 can either record EDID from a display device or a
pre-programmed EDID can be selected using the rotary and DIP
switches.
Recording a display EDID
To record a new EDID into memory:
Turn the rotary switch (1.
d
) to position 0.
N
The DIP switch positions have no effect in this mode.
Apply power to the EDID 101 by connecting a power 2.
source.
N
If power is not available from a video source, an external
12 VDC power supply can be used. The green LED will
be lit when power is available.
Connect the display device to the 3. OUTPUT of the
EDID 101 using a DVI (EDID 101D) or a VGA (EDID 101V)
cable.
N
To capture analog EDID on the EDID 101D, a DVI-A to
VGA adapter must be used.
Power on the display device.4.
N
Although the EDID 101 supplies 5 VDC to power the
EDID circuitry of a display device, power on the display
device to ensure that data is being transmitted during
the recording process.
Press and hold the recessed record button (5.
b
) until the
LED ashes red rapidly, then release the button. The LED
continues to ash red, then returns to solid green when
the EDID data has been stored. The display can now be
disconnected.
N
If an external supply was used for recording, it can now
be disconnected.
Install the EDID 101 into the system. 6.