Filter
Top Products
RGB 460
xixi
xixi
xi Series • Installation and Operation
RGB 460
xixi
xixi
xi Series • Installation and Operation
Installation and Operation
2-3
Installation Overview
CAUTION
Installation and service must be performed by authorized
personnel only. UL Listed electrical boxes are
recommended. See “UL Requirements” in this chapter.
To install and set up an RGB 460xi series interface, follow these steps:
1
Turn all of the equipment off. Make sure that the
computer, the interface, and the output devices (projector/
monitor, speakers) are all turned off and disconnected
from the power source.
2
If applicable, prepare the site (refer to the appropriate
installation guide for information on your specific
situation).
3
Attach the cables. See “Front panel features and cabling”
and “Rear panel features and cabling” in this chapter.
4
Set the rear panel DIP switches. Use the ‘Rear panel
features and cabling” section of this chapter as a guide.
5
Connect power cords and turn on the projector/monitor
and audio device, the interface, and the computer.
6
The picture should now appear, and sound should be
audible. If not, ensure that all devices are plugged in and
receiving power. Check the cabling and the DIP switch
settings, and make adjustments as needed.
7
Disconnect power from all the devices.
8
Mount the interface into the electrical box (refer to the
RGB 400xi Series Installation Guide that addresses your
specific requirements). If optional AAP devices are being
installed (RGB 468xi or RGB 468 Mxi only), see the section
on “Mounting the optional AAP or MAAP device” in this
chapter.
9
Restore power to the devices.
UL Requirements
The following Underwriters Laboratories (UL) requirements
listed pertain to the installation of the RGB 460xi series of
interfaces into a wall or furniture.
1. These units are not to be used beyond their rated voltage
range.
2. These units must be installed in UL listed junction boxes.
3. These units must be installed with conduit in accordance
with the National Electrical Code.
2-2
Interface Details
Front panel features and cabling
The RGB 460xi Dual
(not pictured)
consists of two
RGB 460xi interfaces
placed side-by-side on
a 4-gang faceplate.
RGB 464
xi
INPUT
MONITOR
H. SHIFT
MIN/MAX
AUDIO
VIDEO S-VIDEO
AUDIO
L/MONO R
NO MONITOR
MONITOR
RGB 464
xi
1
2
3
4
5
7
8
9
10
11
12
13
6
RGB 468
xi
INPUT
MONITOR
H. SHIFT
MIN/MAX
AUDIO
NO MONITOR
MONITOR
1
2
3
4
5
6
7
8
14
RGB 468
xi
RGB 460
xi
INPUT
MONITOR
H. SHIFT
MIN/MAX
AUDIO
NO MONITOR
MONITOR
3
4
5
1
2
6
7
8
RGB 460
xi
The
RGB 468 Mxi
(not pictured)
is functionally
identical to the
RGB 468xi
below, except it
fits in a 3-gang
box and
accepts four
mini-AAPs
(MAAPs).