Filter
Top Products
INITIAL SETUP
To modify the RF output channel
setting after the Auto setup is
completed
1
With the VCR turned off, press the
SET
button for
about 3 seconds or more.
The current RF output channel setting will light on
the indicator panel and will appear on the screen.
2
Press the number button
3
(or
4
).
After about 5 seconds, the RF channel setting
value is saved, and the VCR will turn off.
Channel Selection Convenience
You can select a channel on your VCR by using one of
the two methods shown below:
10-KEY RANDOM ACCESS TUNING
Select the desired channel number by using the number
buttons and
100/ENTER
button on the remote control.
For single-digit numbers, press
0
first. For channel
numbers higher than 99, press the
100/ENTER
button
first.
UP/DOWN SELECTION
Press and hold the
CH/TRACK
down (l) or up (j) (or
CHANNEL
on the front panel) button until the desired
channel is received.
NOTE:
When an inactive TV channel is selected on the
VCR, the “No Signal” message appears and the sound is
muted.
Manual Erase
You can eliminate unwanted channels or channels with
weak or scrambled signals from the memorized channel
sequence.
1
Select the channel you want to erase.
2
Press the
CLEAR
button for about 2 seconds.
“Erase” is displayed on-screen for about 3 seconds.
The channel is now erased from the memory.
Manual Programming
You can add channels to the memorized channel
sequence by manually adding them to the tuner memory.
1
Select the channel you want to add using the number
buttons on the remote control.
2
Press the
SET
button for about 2 seconds.
“Add” is displayed on-screen for about 3 seconds.
The channel is now added to the memory.
BASIC OPERATION
SC4H/UF (FVH-T610 GB) Fri. Jan., 07/2000
15