Filter
Top Products
PROGRAM TIMER RECORDING
Setting a Program Timer Recording
Using the Buttons on the VCR
If the remote control does not operate or is not available
you can use the buttons on the VCR front panel to set a
program timer recording.
NOTE:
Eject the cassette tape, before proceeding with
the steps below.
1
Press and hold the REC button on the front panel for
about 5 seconds.
The Timer program menu appears.
If the clock has not yet been set, the Clock set
menu appears.
If necessary, the clock can also be set using the
CHANNEL
l
(or
j
) and
FF
buttons. (Refer to the
next step for button functions.)
2
Use the CHANNEL l (or j) and FF buttons on the
VCR front panel to program the timer.
CHANNEL button: To select numbers or switch
settings
FF button: To select the next item
NOTE:
If you enter the wrong number or setting,
press the REW button to return to the wrong number
or setting, then enter the correct one.
3
When the recording tape speed is set, press the FF
button on the front panel to save the settings.
4
When finished, press the REC button on the front
panel to exit from the menu.
5
Load a cassette.
6
Press the POWER button.
NOTES:
œ Daily or weekly recording, or the program type cannot
be set using this method.
œ Once a program timer recording has been set, it cannot
be erased using the buttons on the VCR front panel.
Checking the Program Timer
1
Turn on the power (TV and VCR).
2
Set the TV to channel 3 or 4.
3
Press the MENU button.
The main MENU appears.
4
Press the OK button.
The programmed recordings are listed.
NOTE:
To display the program type or rating, press
the TYPE button after selecting the desired program
using the ù (or û) button.
5
When finished, press the MENU button to exit the
menu.
6
Press the POWER button.
The VCR power turns off and the timer is set to the
recording standby mode.
The Timer icon
(n)
appears.
Clearing the Program Timer
1
Follow steps
1
–
4
in “Checking the Program Timer”.
2
Press the ù (or û) button to select the program to be
cleared.
3
Press the CLEAR button.
The erase confirmation screen appears.
4
Press the CLEAR button again. (To cancel the erase
procedure, press the SET button.)
The selected timer program is erased from the
program memory.
5
When finished, press the MENU button to exit the
menu.
6
Press the POWER button.
Changing the Program Timer
1
Follow the steps under “Clearing the Program Timer”
to erase the program that you wish to change.
2
Follow the steps under “Timer Programming” to add a
new timer program.
SC4H/UF (FVH-T610 GB) Fri. Jan., 07/2000
35