Fluke 80 Series V Universal Remote User Manual


 
Digital Multimeter
Basic Maintenance
11
5. Place the PCA onto the top shield so that the screw holes align.
6. Place the bottom shield onto the PCA and secure the assembly with five Phillips-head
screws. Ensure that the shields are tightly attached. Properly fitted shields are
required for the Meter to perform to specifications.
LCD
LCD Mask
ama08f.eps
Figure 2. Removing LCD Mask to Access LCD
Reassembling the Meter Case
To reassemble the Meter case:
1. Verify that the rotary knob and circuit board switch are in the
OFF position, and that
the gasket remains secured to the bottom case.
2. Place the PCA into the bottom case.
3. Place the case top on the case bottom.
4. To avoid damaging the battery wire, ensure the wire exits the middle of the battery
compartment.
5. Properly seat the case gasket and snap the case halves together above the LCD end.
See Figure 1.
6. Reinstall the three case screws and the battery door.
7. Secure the battery door by turning the screw 1/4-turn clockwise.
8. Go to “Performance Tests” later in this document, and perform the procedures
described.