Filter
Top Products
E-20
SELECTING INPUT MODE
RGB INPUT MODE
1
RGB1 mode
Press the – buttons to
select the input mode.
You can select from VIDEO1 mode to VIDEO4
mode.
The video modes corresponding to each input
terminal are as follows.
• VIDEO1: SCART (when P-TE1000E is
installed), Video (when P-TE1010E is installed)
• VIDEO2: S-Video (when P-TE1010E is
installed)
• VIDEO3: Comp. video (when P-TE1010E is
installed)
• VIDEO4: Comp. video
* For selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P. E-36.
* You can select between RGB3 and VIDEO4 in
INPUT TERMINALS.
1
* You can also use the buttons
on the display’s control
panel to perform these steps.
VIDEO INPUT MODE
Video1 mode
Press – to select the
input mode.
You can select between the modes from RGB1 to
RGB3.
The input terminal of each RGB mode is as
follows.
• RGB1: DVI-D
• RGB2: mD-sub
• RGB3: BNC
03.1.16, 11:52Page 20
Downloaded From TV-Manual.com Manuals