Fujitsu P-TE1010E Flat Panel Television User Manual


 
E-36
Video Input (when the P-TE1010E is installed)
You can use this option to select the desired video mode of pictures it will receive to the Video Input terminal.
Each time you press or , one of the available modes appears in the following sequence:
Auto1: Automatically selects NTSC, PAL and SECAM.
Auto2: Automatically selects NTSC and M-PAL.
Other than Auto: You need to select a system appropriate to the input signal.
Press to store.
S-video Input (when the P-TE1010E is installed)
You can use this option to select the desired video mode of pictures it will receive to the Video Input terminal.
Each time you press or , one of the available modes appears in the following sequence:
Auto1: Automatically selects NTSC, PAL and SECAM.
Auto2: Automatically selects NTSC and M-PAL.
Other than Auto: You need to select a system appropriate to the input signal.
Press to store.
BNC Input
You can use this option to select the signal system it will receive to BNC Input terminal.
(1) Select BNC Input and press .
BNC Input screen appears.
(2) Select the signal system to receive.
Each time you press or , one of the available choices appears in the following sequence:
Comp.video: For using colour difference input.
RGB-Video: For using 0.3V input of sync. signal level with RGB signal input.
RGB-PC: For using PC wih RGB signal input.
Decoder: For using decoder with RGB signal input.
(3) Press or to select Mask.
(4) Select Comp.video, RGB-Video or Decoder by FUNCTION to set up Mask.
Each time you press or , one of the available choices appears in the following sequence:
Off: Does not mask.
Number:
Masks the fringe (top, bottom, right and left) of the screen by the number of pixels specified.
(5) Press to store.
BNC-Input selection screen
This fringe part is masked.
OTHER ADJUSTMENTS (FEATURES MENU) (Continued)
03.1.16, 12:00Page 36
Downloaded From TV-Manual.com Manuals