FUNAI LC195EM9 2 Flat Panel Television User Manual


 
15
EN
WATCHING TV
INTRODUCTION
PREPARATION INITIAL SETTING OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
Still Mode
You can pause the image shown on the TV screen.
Press
[STILL] to pause the image shown on the TV
screen.
Still
The sound output will not be paused.
If no signal is detected or protected signal is received
during still mode, the image remains paused and the
sound output will be muted.
The still function will be released after 5 minutes.
To cancel still mode, press any button except [POWER].
Switching Each Input Mode
You can easily switch with the remote control to the DTV (ATSC) and TV
(NTSC) or to access external devices when they are connected to the unit.
Press [INPUT SELECT] or [CH. K] repeatedly to cycle
through the input modes.
or
or
Video1
Video2
PC
DTV/TV channel
Pressing [CH. L] reverses the direction of the input
modes.
To use the video or S-video input jack on the unit,
select “Video1”.
To use the component video input jacks on the unit,
select “Video2”.
To use the PC input jack on the unit, select “PC”.
5
5
Switching Audio Mode
This section describes how to switch the audio in the analog mode and how
to switch the audio language in the digital mode.
TV
1
Press [AUDIO ] to display the currently selected
audio mode. While receiving an MTS broadcast,
press repeatedly to cycle through the available audio
channel.
6
SAP / STEREO
When all audio are available
SAP / STEREO SAP / MONO
SAP / STEREO
When stereo and monaural audio are available
MONO / STEREO MONO / STEREO
When SAP and monaural audio are available
SAP / MONO SAP / MONO
When only monaural audio is available
MONO
STEREO : Outputs stereo-audio
SAP : Outputs second audio program
MONO : Outputs mono-audio
DTV
1
Press [AUDIO ] to display the currently selected
language and the number of available languages.
6-1
English 1/3
2
Press [AUDIO ] repeatedly to cycle through the
available audio languages.
Available languages differ depending on the
broadcast. “Other” is displayed when the audio
language cannot be acquired, or the acquired
languages are other than English, Spanish or French.
Note:
• Pressing [AUDIO ] does not control external audio
devices.
• The information display will automatically disappear in a
few seconds.
5
(Cannot be switched)
A8AN5UH_A8AN3UH_A8AN1UH_EN.indd 15A8AN5UH_A8AN3UH_A8AN1UH_EN.indd 15 2008/03/05 15:48:502008/03/05 15:48:50