FUNAI LC195EM9 2 Flat Panel Television User Manual


 
8
EN
P
REPARATION
Basic Connection
This section describes how to connect the unit to an antenna, cable/satellite box, etc.
Note:
• Be sure your antenna or other device is connected properly before plugging in the power cord.
[Antenna Connection]
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.
e.g.)
Once connections are completed, turn on the unit and begin initial setup.
Channel scanning is necessary for the unit to memorize all available channels in your area.
(Refer to “Initial Setup” on page 12.)
Note:
• For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the
unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop versions.
• To switch your reception source easily between antenna and cable, install an antenna selector.
• If you connect to the cable system directly, contact the CATV installer.
[Connection to Cable Box or Satellite Box]
Use an RF coaxial cable to connect the antenna input jack of the unit to the antenna output jack of the cable/satellite box.
e.g.)
ANT OUTANT IN
STEREO
PCM
Required cables and connecting methods differ depending on the cable/satellite box.
For more information, please contact your cable/satellite provider.
5
*
*
Cables not included.
Please purchase the necessary cables at your local store.
VHF / UHF
antenna
RF coaxial cable
or
cable TV
company
rear of this unit
satellite dish
cable/satellite box
cable TV
company
or
rear of this unit
RF coaxial cable
RF coaxial cable
A8AN5UH_A8AN3UH_A8AN1UH_EN.indd 8A8AN5UH_A8AN3UH_A8AN1UH_EN.indd 8 2008/03/05 15:48:412008/03/05 15:48:41