Filter
Top Products
14
EN
W
ATCHING TV
Channel Selection
Select channels by using [CH.
K
/
L] or [the Number buttons].
Use
[CH.
K
/ L] or [the Number buttons] to select the
memorized channels.
or
or
Using [the Number buttons]
TV
When selecting analog channel 12
DTV
When selecting digital channel 12-1
Be sure to press [–] before entering the minor
channel number.
Press [CH. RETURN
] to return to the previously
viewed channel.
Only [the Number buttons] can be used to select
the non-memorized channels.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously. Therefore, you can
select more than one program per major channel since
digital broadcasting technology distinguishes between
multiple channels broadcast by a single network.
18:00
18:30
19:00
19:30
20:00
20:30
NTSC (analog mode)
[Air Time]
ATSC (digital mode)
major channel minor channel
: change automatically
: change manually by using [CH.
K / L]
CH4
CH4
CH4
CH4
CH4
No signal
No signal
No signal
CH4-1
CH4-2
CH4-2
No signal
CH4
(high definition TV)
CH4-1
Note:
• “No Signal” will appear on the TV screen after the minor
channel broadcast is over.
• “Audio only program“ message will appear on the TV
screen, when you receive only sound signal.
5
-
-
•
•
•
Volume Adjustment
This section describes how to adjust the volume. The mute function, which
turns the sound off and on, is also described.
Use [VOL.
X
/
Y
] to adjust the audio volume.
or
Volume 20
The volume bar will be displayed at the bottom of
the TV screen when adjusting the volume.
The volume bar will automatically disappear in a few
seconds.
Press [MUTE ] to turn off and on the sound.
Mute
“Mute” is displayed on the TV screen for a few
seconds.
Press [MUTE ] again or use [VOL.
X
/
Y
] to recover the
original volume.
Sleep Timer
The sleep timer can be set to automatically turn off the unit after an
incremental period of time.
1
Press [SLEEP ] to set the sleep timer.
Sleep
Off
Sleep timer display appears on the TV screen.
2
Press [SLEEP ] repeatedly to change the amount of
time until shut off.
Sleep
120min.
You can set your unit to turn off after a set period of
time (from 30 to 120 minutes).
Each press of [SLEEP
] will increase the time by 30
minutes.
After setup, the sleep timer display can be called up
for checking by pressing [SLEEP ].
To Cancel the Sleep Timer
Press [SLEEP ] repeatedly until “Sleep Off” is
displayed on the TV screen.
Note:
• The sleep timer display will automatically disappear in a
few seconds.
• When you disconnect the unit from the AC outlet or when
a power failure occurs, the sleep timer setting will be
canceled.
5
•
•
•
5
•
•
•
•
A8AN5UH_A8AN3UH_A8AN1UH_EN.indd 14A8AN5UH_A8AN3UH_A8AN1UH_EN.indd 14 2008/03/05 15:48:472008/03/05 15:48:47