Filter
Top Products
30
EN
Checking, canceling, or correcting the timer programming
information
Recording
1
Press [STANDBY-ON].
TIMER REC indicator will be off on
the front panel.
2
Press [TIMER PROG.].
Timer Programming list will appear.
3
Check the information on the
list you will need.
4
To clear the timer programming:
Using [K / L], select the
program. Press [CLEAR].
To correct the timer program-
ming:
Using [K / L], select your desired
program. Press [OK].
Next, correct the timer
programming by using [K / L / {
/ B]. Finally, press [OK] again.
5
Press [TIMER PROG.] to exit.
6
Press [STANDBY-ON] to return
to the timer standby mode.
Note
• Press [TIMER PROG.] to
check the timer programming
in process.
When the Timer Recording is
proceeding, that program will
be highlighted with red. In this
case, you cannot select any
other program.
Press [CLEAR] to erase the
selected program.
Each error number means:
Timer Programming
2. ---
1. JAN/01 12:57AM 1:57AM CH 8 HQ
Date Start End CH Mode
To stop the Timer Recording in process
Press [STOP C] on the front panel of the unit.
[STOP C] on the remote control is not effective.
If the timer program did not complete correctly, the error number
appears in the Timer Programming list.
Timer Programming
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
*
JAN/01 12:57AM 1:57AM CH 8 E22
Date Start End CH Mode
• A program with the error number is grayed and asterisked in the Timer Programming list.
• Once the Timer Programming list with error line(s) is displayed, or after canceling and setting again the timer
standby mode, the program line(s) with error will be cleared.
Timer Recording (cont’d)
E1-22
E37-39
Recording error other than
below
E41 Power failed
E24 Unrecordable disc E42 No disc when recording
E25-26 Copy prohibited program E43 Already 49 titles recorded
E29 Disc protected E44 Already 254 chapters
recorded
E30 Disc full E45 Copy prohibited program
E35 PCA full E46 It is impossible to record
additionally on a disc
recorded by other units
when setting Replace Disc
Menu to OFF.
E36 Already finalized Video
format disc
E40 Some portion has not
been recorded because
of program overlapping.
Recording did not start at
the start time.
• E23,E27,E28,E31,E32,E33 and E34 are not displayed.
STANDBY-ON
.@/: ABC DEF
GHI
OPEN/CLOSE
ZOOM
TIMER
PROG.
1
PQRS
4
DISPLAY
7
TITLE
REC MODE
RAPID PLAY
REC
REV
PREV
PLAY
PAUSE
STOP
FWD
NEXT
CM SKIP
JKL
2
TUV
5
SPACE
8
DISC MENU
0
MNO
3
WXYZ
6
CLEAR
9
RETURN
CH
REPEAT
SETUP
OK
4
1
6
2
5