Filter
Top Products
20 EN
STOP
STANDBY-ON
TIMER SET
TIMER
PREV NEXT
OPEN/CLOSE
SPACE
123
456
78
0
9
CH
VIDEO/TV
SLOW
PAUSE
.@/:
ABC DEF
GHI JKL MNO
PQRS
REC
DISPLAY
TUV WXYZ
DVD
REC
REC MODE
ZOOM
SEARCH
VCR
SETUP
CM SKIP
RETURN
DISC MENU
TITLE
DUBBING
RAPID PLAY
CLEAR
OK
PLAY
AUDIO
Channel setting (cont’d)
Getting started
4
Select the channel number to
add or delete.
Press [{] or [CH L] to move to a
lower channel number.
Press [B] or [CH K] to move to a
higher channel number.
Press the Number buttons to
select a channel number directly.
5
Using [K / L], select “Add” or
“Delete”. Press [OK].
The channel number will be
added or deleted from the channel
memory. Then the next channel
number will appear so that you
can continue adding or deleting
channels.
6
Press [SETUP] to exit.
Adding/deleting
channels
The channels you no longer
receive or seldom watch can
be deleted from the memory.
You also may add channels into
memory.
1
Press [SETUP].
2
Using [K / L], select “Channel”.
Press [OK].
Channel menu will appear.
3
Using [K / L], select “Manual
Channel Preset”. Press [OK].
Manual Channel Preset menu will
appear.
Manual Channel Preset
CH 2
Add
Delete
VCR DVD
3
4
5
6
Manual Channel Preset
CH 7
Add
Delete
VCR DVD
Note
• [CH K / L] works on the
memorized channel in this
unit.
• [{ / B] works on all of the
channel numbers.
Note
• You cannot change the channel when one of the components of the unit (VCR or DVD) is in the recording,
the One-touch Timer Recording or Timer Recording mode.
• If the auto presetting is canceled during presetting, some of the channels not yet preset may not be received.
• The selection will depend on how you receive the TV channels.
Press [RETURN
] or [SETUP] to cancel the auto presetting during scanning.
To select a channel
You can select a channel by directly entering the channel using the Number buttons on the remote
control.
Notes for using the Number buttons:
• When selecting cable channels which are higher than 99, enter channel numbers as a three-digit number.
(For example: 117, press [1], [1], [7])
• You must precede single-digit channel numbers with a zero (For example: 02, 03, 04 and so on).
• You can select the line input mode (“E1” or “E2”). To select “E1” by pressing [0], [0], [1]. To select “E2” by
pressing [0], [0], [2]. Details are on pages 35-36.
1
2
4