GE Capital 24959 Universal Remote User Manual


 
10
Programming Combo Device Codes
Some combo (combination) devices (TV/DVR, TV/
DVD, DVD/DVR, etc.) require you to set up 2 dif-
ferent modes to control both parts of the combo.
For example, if you have a TV/DVD combo, you
might need to set up one code under the TV mode
to control the TV and a separate code (under other
modes) to control the DVD.
DVD/DVR Punch-Through Feature
This remote allows the 6 DVD/DVR transport
buttons (i.e. PLAY, PAUSE, STOP, FF, REWIND,
and REC) to operate the programmed TV, DVD,
SAT, DVR, Cable device if the code has these
button functions e.g. if you hvae programmed
a SAT/DVR or Cable/DVR, etc. Otherwise the
transport keys will punch-through to the last DVD
or VCR programmed mode you used, i.e., the
transport buttons control your DVD or VCR player
even when you are in TV, SAT or Cable mode. If
you want to enable this Punch-through feature to
allow the transport keys to always control your last
used DVD or VCR, please use the following steps:
1. Press and hold SETUP until the red indicator
stays on, then release the SETUP button.
2. Press and hold PAUSE until the red indicator
turns off, then release the PAUSE button. The
PAUSE button needs to be held held for about
3 seconds before the red indicator turns off.
The punch-through feature can be disabled again
by repeating the above steps.
Volume/Mute Control and Punch-
Through Feature
Your remote allows you to select which device
mode controls VOLUME and MUTE. This remote
is initially set for all device modes to use their own
Volume/Mute control if present.
If the programmed code does not have Volume/
Mute operation, then VOLUME and MUTE will
“punch-through” (hand-over) control to the TV-
mode device without you needing to change to TV
mode. Note: Any mode chosen for Volume/Mute
control must have its own Volume/Mute function or
else VOLUME and MUTE will not function.
Setup